NOTE:
The mat will automatically
centre in the frame when in use.
3
4
5
Insert the Handle
assembly inside the
square frame and line up
the holes in the Handle
sides with the two centre
holes in the Spacers.
Threading the Mat
Starting at one corner thread the elastic cord around the legs
and up through the two mat eyelets as shown.
Ensure that both the lengths of elastic cord are equal in length.
When the last eyelets have been threaded by
both ends of the elastic cord (should be at one
corner) push the flexible plastic sleeve over one
end and thread the metal hook through the
eyelet in the elastic cord (as shown). Then hook
on the other side of the elastic cord and cover
the joint with the plastic sleeve.
1. Threading First Corner
Start threading the elastic cord
to the frame as shown.
Ensure
that the elastic cord is as tight
as possible whilst threading.
2. Threading Middle change-over
N.B when eyelet 3 is reached change the threading pattern.
Take the elastic cord around the leg tube as before, but now
push the elastic cord
down
through eyelet 4 and around the
leg tube (as shown) Repeat until the side is threaded.
3. Threading Second Corner
When eyelet 6 is reached thread the elastic cord around the corner as
shown and repeat the above until the remaining three sides are threaded.
(Don’t worry if the mat is not central with the frame at this point).
Push the short bolts through the spacers
and the Handle until the bolt heads are
within the spacer recesses. Add the
remaining washers & nuts, tighten using
the spanners provided, then add and
tighten the Dome nuts
2 3 4 5
4
5
6
1
Sleeve
Sleeve
Hook
