MV Agusta 2008 F4 312RR 1078, Руководство по ремонту

Страница: 46 / 124

- 16 -
Cylinder kit
C
Progressively move the internal hexagonal screws
close. Tighten the screws at a torque of 12 N·m.,
always beginning from n°2 and n°3 stands.
Check to be sure that the valve cap gaskets are in
good condition.
Apply a layer of gasket 5552 silicone on the semi
moons on the head in correspondence with the cams-
haft.
Position the valve cap.
Manually position the screws, thus tighten at 8 Nm.
Place the adduction oil tube at the head greasing the
O-Rings.
Dismounting cylinder head pieces
In order to carry out this procedure the following tools
are necessary:
tool n° 800094796 to disassemble valves
tool n° 800095179 to remove semi cones
tool n° 800094798 to take out rubber holdings
Each piece relative to the same valve (cup,
spring, semi cone, etc.) must be reassemb-
led onto the same valve from which it came
off.
Remove the cylinder head as indicated the paragraph
“cylinder assay removal”.
800095179
8 N•m