MuxLab PRODIGITAL 500791, Руководство по эксплуатации

Страница: 20 / 47

HDMI/IP PTZ Camera Operation Manual
20
Network Function
1
Operating Environment
Operating System: Windows 2000/2003/XP/
vista/7/8/10
Network Protocol: TCP/IP
Client PC: P4/128MRAM/40GHD and higher,
supporting scaled graphics card with DirectX 8.0
and higher.
2
Equipment Installation
1) Connect the network port on the camera to your
network or directly to your PC via an Ethernet cable.
2) Plug in the 12VDC power supply to turn on the
camera.
3) The orange LED on the network port will light
up and the green LED will flash to indicate that the
physical network connection is complete.
3
Internet Connection
The below shows the possible connection methods
described above between the camera network port
and computer as in figure 1.1, or to the network as
in figure 1.2 below:
Figure 1.1 Direct connect to PC
Figure 1.2 Connect via router/modem
4
IP camera control via LAN
4.1
Setup IP address
The camera default IP address is: 192.168.100.88,
If the camera IP address in unknown, it may be
found as follows:
Method 1: press * and then # and then 4 on remote
controller (one key after another), the camera IP
address will be shown on an attached HDMI
display.
Method 2: connect the camera directly to a PC via
an Ethernet cable, and use the "upgrade_En.exe"
application to search for the IP address
The IP address may be changed in the following
two ways:
Method 1: On web interface, go to "Network" =>
Change IP => make your change => Click "Apply"
=> Restart the camera.