MuxLab PRODIGITAL 500791, Руководство по эксплуатации

Страница: 14 / 47

HDMI/IP PTZ Camera Operation Manual
14
Serial Communication Control
In default mode, the camera can connect to a VISCA controller with an RS232C serial interface.
➢
RS232 Communication Settings:
The camera may be controlled via RS232 when set to the following parameters:
Baud rate: 2400, 4800, or 9600 bit/s.
Start bit: 1 bit.
Data bits: 8 bits.
Stop bit: 1bit.
Parity bit: none.
When the camera is turned on, the Pan-Tilt function will move to the maximum top-right position and
then will return to the center (Home) position to complete an initialization process. (Note: If the position
preset 0 has been stored, the position preset 0 will be called up after the initialization step). After the
initialization process users can control the camera via the control commands in the below command list.
PTZ over TCP/UDP Control
The camera supports a TCP server via port number 5678. After the client establishes a TCP connection
with the server, the client may send PTZ control commands to the server to be executed.
A UDP server is also available via port number 1259. Once the client establishes a UDP connection with
the server, the client may send PTZ control commands to the server to be executed.
Command List
The Visca and Pelco-D command List may be found in the Appendix.