© MuxLab Inc.
6G-SDI Extender Over FIBER
Page 14
3.4.
Installation & Power-up Procedure
In order to install the product, please follow the steps
below:
1.
First, install the Transmitter near the SDI signal
source. Attach the unit via the mounting holes or by
other appropriate means.
2.
Connect the necessary number of SDI Compatible
75Ω Coax cables in order to carry the video/audio
signal. Always start by connecting the first cable to
the BNC A, then B and so on.
3.
Once the Transmitter is installed and connected with
the SDI coax cables, then connect and run the fiber
optic cable from the Transmitter to the Receiver unit,
using either multimode or singlemode fiber
depending on the 6G-SDI Extender model being
installed. Respect the distance specification listed on
Table 1.
4.
After hooking up the fiber optic cable to the SFP+
port on the Receiver, proceed to connect the SDI
coax cables from the Receiver to the destination
device (e.g.: Recorder, Monitor, Capture card, etc.).
5.
Once all the cabling is installed, next plug the
12VDC wall-mount power supplies to both the
Transmitter and Receiver.
6.
Each unit will power up and auto-initialize.
7.
Next the fiber link will sync, and the link indicator
on each unit will blink after the negotiation process
has successfully completed.
8.
If the source is generating a video signal at the
Transmitter end, then the Receiver will output the
