MUTOH VJ-626UF, Руководство по эксплуатации

Страница: 63 / 144

Set 1: User Type 63
Steps
1.
Print a “PF1: Initial Print”, and measure the distance between the “+” marks with a ruler.
2.
Enter the distance measured as the “Initial Change”.
3.
Determine the feed length for the “PF3: Confirm Print”, print it, and measure the distance between
the “+” marks with a ruler.
• Check that there is no deviation from the feed length.
4.
Print a “PF4: Micro Print”, and find the pattern with the least white streaks and image overlaps.
• The numeral below that pattern is the micro adjustment value.
5.
Enter the micro adjustment value according to the test pattern print in Step 4.
**>3: PF Adjust
Performs media feed adjustment.
• Required media size: width 210 mm x length 110 mm.
• A ruler is required for this adjustment. Please prepare a commercially available
ruler.
When the following defects are found in your prints, they may improve by
conducting a paper feed correction.
• Images are overlapping.
• There are white lines in images.
Submenus
"PF 1. Initial Print" on page 64
"PF2. Initial Change" on page 64
"PF3. Confirm Print" on page 65
"PF4. Micro Print" on page 66
"PF5. Micro Change" on page 66
**> 3 : PF Adjust >
PF1 : Initial Print
PF2 : Initial Change
PF3 : Confirm Print
PF4 : Micro Print
PF5 : Micro Change