MUTOH VJ-626UF, Руководство по эксплуатации

Страница: 65 / 144

Set 1: User Type 65
PF3. Confirm Print
• With a ruler, measure the length between “+” in the pattern.
• If there is discrepancy between the value set for “FeedLength” and the value measured, carry the procedure out again from
1. “Initial Print”. If there is no discrepancy, go to 4. “Micro Print”.
• In the example below, the measured place is shown in blue dotted lines and arrows (the blue parts are not actually printed).
Performs Confirm Print. Enter the “FeedLength”, and press the [Enter] key.
Print a “+” mark at the beginning, feed the media according to the setting value,
and print another “+” mark.
Setting values
100 mm to <250 mm> to 550 mm
<> indicates the default setting.
PF3 : Confirm Print
FeedLength : 250 mm