MUTOH VJ-1638UH Mark II, Руководство по установке

Страница: 8 / 16

VJ-1638UH Mark
Ⅱ
INSTALLATION MANUAL
VJ1638UH2E-I-02 8
6 Turning the power ON/OFF
6.2 Set sleep mode on the printer
7. Product activation
This printer requires activation when the power is
turned ON for the first time.
When “Activation required” is displayed on the
Operation panel, refer to “Product activation guide”*
to perform activation.
*Please download the “Product Activation Guide”
from the MUTOH Club below.
https://club.mutoh.co.jp/mutoh/guser
6.1 Turning the power ON
Follow the procedure below to turn the power ON.
This section explains how to turn the printer
ON/OFF, and how to start the sleep mode.
5.3.13 Ink Status menu
6.3 Before using sleep mode for a long time
6.6 Disposal the waste fluids
You need to let the ink flow inside the
printer regularly, therefore, do not turn OFF
the printer after regular operation; make
sure you use the sleep mode.
If you have to turn OFF the printer, read
“3.2.2 Turning the power OFF” in the
Operation Manual.
1. Press the [Power] key on the operation panel to
turn ON the printer.
1. Make sure that the printer's operating condition
is as follows:
•
“Sleep Mode1: Start” is displayed on Operation
panel.
• “Start Sleep Mode?” is displayed on Operation
panel.
2. Press the [Menu] key on Operation panel.
3. Press the [>] key on Operation panel.
4. Press the [Enter] key on Operation panel.
5. Press the [Enter] key on Operation panel.
• The Power lamp on the operation panel lights
up in blue.
• Printing or other operation is not in progress.
•
Operation panel display is in the Normal condition.
•
The ink amount is at a sufficient level.
•
Front cover and maintenance cover are closed.
•
Media loading lever is lowered
(Media loading lever on the rear side is raised).
•
Front cover or Maintenance cover is open.
•
Front media loading lever is raised
(Rear media loading lever is lowered).
•
Waste fluid tank is full.
•
The ink cartridges has been removed.
•
Not genuine ink cartridges are inserted, etc.
• There is enough free space in the waste fluid bottle.
• “Menu1: Sleep Mode” is displayed on Operation
panel.
•
The printer starts initial operation.
•
When the initial operation is complete, the printer
enters Normal.
If there is a problem during the initial
operation, a message is displayed on
the operation panel and the printer
may stop operating.If operation stops,
refer to “7 Troubleshooting” and deal
with the problem.
• “Daily Maint.: Start” is displayed on Operation panel.
• “Restart -> ENTER” is displayed on Operation panel.
•
The printer goes into sleep mode.
If you press the [Enter] key during sleep mode, the
printer returns to the Normal condition. If the
printer is under one of the following conditions
while shifting to sleep mode, “Don’tStartSleep-
Mode” is displayed, and sleep mode does not start.
Activate Sleep Mode again after returning the
printer to a normal state.
Operation Manual “7.2 Error messages”
Make sure you perform daily maintenance.
If the printer goes into Sleep mode or the
power is turned OFF without daily
maintenance, nozzles may get clogged.
WARNING
8. Press the [Enter] key on Operation panel.
• “Daily Maint.: End” is displayed on Operation
panel.
6. Press the [Enter] key on Operation panel.
7. Perform daily maintenance.
NOTE
Daily Maintenance Sheet for VJ-1638UH Mark
Ⅱ
NOTE
CAUTION