11
ENGLISH
POW ON SEL (POWER ON SELECTION)
SPK:
the CH1 input channel of the high level speaker inputs and its Auto Turn-On function.
Refer to page 9 and section 6 for more details.
REM:
the REM and a turn-on signal from head unit/car stereo.
Refer to page 9 and section 6 for more details.
-
TOSLINK connector.
DRC
This input is suited for an external MUSWAY digital remote controller.
Check the website
“www.mus
way.
de
”
for more information or ask your car audio retailer.
OPT IN
8
10
9
SYSTEM CONFIGURATION
Before turning on the system, set the head-unit output level to a lower level (approximately
20% of its maximum excursion) to avoid damaging the speakers during calibration.
WARNING
aware of what type of system you intend to set up. In order to avoid complications in preparation, make sure
the following points before you start:
• The type of signals that will be assigned to the inputs (e.g.: front left or center or subwoofer, etc.).
• The speakers in the system (e.g.: 3-way front or sub stereo or 2-way rear, etc.).
• If there are passive crossovers that manage groups of speakers (e.g.: 3-way systems with active
midrange).
•
.
•
T mode), thus increasing the power on
the output.
12
HI.LEVEL SENS
You can select the input senstivity (10V or 18V) for high level.This function is suited to match the outp-
ut voltage of the connected signal source with the amplifier.
CLIP
This LED lights up red if one of the 8 high level inputs (CH1-8) is overdriven. The LED has no function
when an input signal is applied to the Optical input and the Bluetooth™ input. If this LED lights up
reduce the input sensitivity by using the regarding controller Input Sensitivity until the LED goes out.
11