Mustang Survival RESCUE STICK MRD100, Руководство пользователя, Страница: 9 / 12

Step 3 - Remove clear inflator cap by turning counter-clockwise (Fig. 9).
FIGURE 9
FIGURE 10
Step 4 - Remove the bobbin from the cap. Discard the bobbin. Check the housing to be sure it is
clear of debris, clean and dry (Fig. 10).
CAUTION: The bobbin body may remain in the housing or in the cap assembly when you
remove the cap. The bobbin body must be removed prior to assembly.
RE-ARMING
WARNING: CO2 cylinders are under EXTREMELY high pressure. Failure to
install a bobbin prior to the installation of the CO2 cylinder could result in a
premature puncture of the CO2 cylinder. CO2 cylinders contain freezing liquid
CO2 at -50ºF which could cause serious skin burns and eye injury. A punctured
unrestrained CO2 cylinder can travel at high velocities which could cause
serious injury or death.
WARNING: In order to properly re-arm the device, steps 1 - 4 must be followed exactly.
IMPORTANT: Bobbin must be installed into the inflator HOUSING before screwing on the
inflator cap.
IMPORTANT: Check the date on the bobbin in the re-arm kit. The date should
not be more than three (3) years previous to today’s date. If more than three
(3) years, DO NOT USE and discard the expired bobbin.
Step 1 - To install a valid bobbin, align the slots on the bobbin with those on the housing. The
bobbin will slide in easily if installed correctly (Fig. 11).
FIGURE 11 FIGURE 12
Step 2 - Install cap by screwing clockwise until it meets the housing shoulder (Fig. 12).
6 Rescue Stick
™
Owner’s Manual