• Enables quick convenient continuity cable testing for all types of cables
• Tests cables with all types of combinations of the following connectors:3.5mm&6.35mm TRS, balanced XLR (M/F),
Phono/RCA, banana plug,4-pin&8-pin Speakon, 4-pin S-type socket and 3-pin,5-pin,7-pin and 8-pin, CAT5 (network)
• LED’s confirm each conductor continuity and connection
• 9-way switch for selecting connections to be tested . Also includes internal battery and ground connection status checks
• Rugged, compact, metal construction for ultimate roadworthiness, long life, and reliability
At first, turn the rotary switch fully clockwise to test the battery strength. The battery LED will light bright green if the internal
battery is fully charged.
Then plug one end of the cable into the appropriate jack on the left side panel of the cable tester. Plug the other end of the
cable into the appropriate jack on the right side panel. Set the rotary switch to “1” to test the connection of contact 1 on the
plug inserted into the left side panel.
If there is a connection, the Green LED will light below “1” and a Yellow LED will light above each contact on the right side
plug connected to “1” on the left side plug. Use the charts below to verify proper cable connections.
If no LED lights then there is no connection and the left side contact “1” is “floating” due to design or an “open” in the cable.
Set the rotary switch to “2” to test contact 2, and so on, until all contacts have been checked.
If the Ground LED lights then there is a connection between the corresponding contacts and the chassis.
To test the cable with a banana plug, just plug each end of the cable into the banana jacks. The LED will light and the unit
will beep a tone if there is a connection between the plugs. These banana jacks can also be used for continuity tests using
two probe leads.
1/4”Ts Mono to 1/4” Mono
1 Sleeve
1 Sleeve, 3 Ring
2 Tip
2 Tip
3 Ring
1 Sleeve, 3 Ring
(shorted with sleeve)
Jack speakon Phono
1=sleeve
1= -1 5= -3 1=screen
2=TIP
2= +1 6= +3 2=hot
3=ring
3= -2 7= -4
4= +2 8= +4
Xlr balanced to Xlr balanced
Pin 1
Pin 1
Pin 2
Pin 2
Pin 3
Pin 3
1/4”Ts Mono to Xlr unbalanced
1 Sleeve
Pin 1, Pin 3
2 Tip
Pin 2
3 Ring
Pin 1, Pin 3
(shorted with sleeve)
1/4”Trs to 1/4” Trs
1 Sleeve
1 Sleeve
2 Tip
2 Tip
3 Ring
3 Ring
Xlr unbalanced to Xlr unbalanced
Pin 1
Pin 1, Pin 3
Pin 2
Pin 2
Pin 3
Pin 1, Pin 3
1/4”Trs to Xlr balanced
1 Sleeve
Pin 1
2 Tip
Pin 2
3 Ring
Pin 3
Features:
Cable testing:
