MUSIC HALL MMF-2.1, Инструкция по эксплуатации

Страница: 10 / 13

10
MAINS CONNECTION
The turntable is delivered with a fixed power cord for 110V/60Hz (13). Connect
this to the mains.
AUDIO CONNECTION
The Music Hall Tracker is a moving- magnet cartridge. Connect the audio cable
(14) to the MM (Moving Magnet) hono input on your receiver or pre-amplifier.
OPERATION
Place a record on the platter and push the mains switch (20) to the 'ON' position.
Remove the stylus guard and lift up the tonearm with the cueing lever (7).
Position the cartridge stylus tip above the initial groove of the record. Gently
lower the cueing lever (7) to drop the arm onto the record.
To stop play, lift the cueing lever (7) to raise the arm and then bring the tonearm
back to the tonearm rest (8). Push the mains switch (20) to 'OFF'.
It is recommended to replace the stylus guard (optional) when the turntable is not
in use.
To play 45 rpm records, first remove the felt mat and platter then move the drive
belt (3) from the small to the large diameter rim of the stepped motor pulley (2).
Do this using the belt-changing tool (19) so as not to touch the belt with your
hands. Replace the platter and felt mat. Please note, for singles (7 inch records
with a large center hole), you may need to use the black 45 rpm adaptor. Simply,
center the adapter over the spindle and set it on top of the felt mat. Place the
single on the platter and play.
MAINTENANCE
The MMF-2.1 is designed for a long operational life. To preserve the appearance
of your deck and maintain its performance, you should note the following points
when cleaning (Make sure the stylus guard is in place before you begin):
PLINTH - The plinth is constructed from medium density fiberboard, therefore it
should not be subjected to extremes of temperature or direct sunlight. The finish
may change slightly with age. A damp cloth or soft duster is ideal for cleaning the
plinth; polish, particularly wax-based, can be hard to remove.
PLATTER - The alloy platter can be cleaned with a soft, dry, lint-free cloth.
MAT - Clean the felt mat with masking tape.
MOTOR - The motor is equipped with self-lubricating bearings. The motor pulley
should be cleaned periodically to remove deposits of rubber shed by the belt.
Remove the outer platter and belt. Gently clean with a cotton swab or lint-free
cloth dampened with isopropyl alcohol.