5
integrated amplifier
integrated amplifier
When connecting a turntable to the phono input, connect the RCA's as described above.
Connect the turntable's ground wire to the ground screw (GND) and move the cartridge switch
to the correct position; MM for moving-magnet cartridges or MC for moving-coil. If unsure of
the correct cartridge setting consult the literature accompanying your cartridge or your dealer.
The cartridge switch sets the correct loading and level of amplification for the cartridge.
Do
not flip the cartridge switch with the a50.2 powered on.
Pre Out
This output is always active and can be used to connect the a50.2 to a subwoofer or additional
power amplifier. Simply connect this output to the input on your subwoofer or amplifier.
Speaker Outputs
To avoid damage to the a50.2, make sure it is
plugged into an AC outlet while connecting
up or disconnecting speaker wire to the speaker outputs. The a50.2 has one pair of speaker
outputs on the back labeled SPEAKER OUT; RIGHT and LEFT. Using a suitable speaker wire,
connect the right speaker to the RIGHT SPEAKER OUT and the left speaker to the LEFT
SPEAKER OUT.
Pay careful attention to match the positive (red) and negative (black)
terminals on your speakers to the positive (red) and negative (black) terminals on back of the
a50.2.
NOT
Connecting to the Mains - Plugging In
Check that the Power Switch on front of the a50.2 is in the
position. Push the plug (IEC line
socket) of the power cable supplied with the a50.2 into the socket (AC IN) on back of the unit.
Make sure it is pressed in firmly. Plug the other end of the power cable into an AC wall outlet.
off
Connect your source components to the appropriate inputs on back of the a50.2. Pay careful
attention to match the right (red) and left (black) outputs from your source components to the
right (red) and left (black) inputs on the a50.2. Connect to the ipod input on the front using a
3.5mm stereo mini-plug.
