Murray 11052x4NC, Инструкция

Страница: 9 / 72

ASSEMBLY
9
F–041306C
11. Remove the shut-off switch, switch
bracket, screw, and wire harness from
the parts bag.
12. Mount the throttle control and shut-off
switch to the right handle. Secure the
eyelet, the shut-off switch, the switch
bracket and the throttle control to the
handle
with the
screw
as shown in
Figure 6.
13. Connect the terminal to the shut-off
switch (see Figure 6).
14. Connect the other end of the wire as-
sembly to the two wires at the rear of
the engine (see Figure 7).
NOTE: If the shut-off switch wires are
not properly connected, the shut-off
switch will not stop the engine.
15. Attach the throttle control cable and
the wire assembly to the upper and
lower handle with the tie strap (see
Figure 8) . Thread the pointed end of the
tie strap through the other (square) end
of the strap. Pull the tie strap tight
around the throttle cable and the lower
handle.
NOTE: One side of the tie strap is
rough, the other side is smooth. The
rough side must be on the inside of the
loop formed when the ends of the tie
strap are put together.
16. Try to loosen the tie strap. If it will loos-
en, it is put together with the smooth side
to the inside of the loop. Remove the tie
strap and reverse the direction.
17. Cut off the excess strap.
Figure 6
Throttle
Control
Screw Eyelet
Shut-off
Switch
Switch
Bracket
Terminal
Figure 7
Wire Assembly
Figure 8
Tie Strap