Murphy M2, Руководство по установке

Страница: 8 / 38

Section 50 00-02-0674
04-16-10 - 4 -
Installing the M2 Wireless Gateway and Antenna
Mounting the Gateway
Mount the M2 Gateway on a DIN rail inside the
panel enclosure.
The M2 Gateway can be mounted vertically or
horizontally on a standard DIN rail. Two clamp-
type feet along the bottom of the Gateway attach
to the DIN rail.
NOTE : Rail stops are recommended to
prevent sliding.
Power
Power up the Gateway by attaching a power cable to the GND/BAT terminals and connecting
to a battery or power supply. Voltage must be between 8-32 volts DC.
Antenna Mounting
1. Mount the antenna bracket to the top of the panel, or
other structure, no more than 12 feet away from the
Gateway.
2. Attach the antenna coax cable to the Primary
Antenna connection on the Gateway. Feed cable
down and outside of the panel through a free
conduit hole. It is recommended that the coax cable
be run separately from other cabling and kept away
from noise sources such as the “G-Lead, cell
modem cabling, antenna, etc.
3. Attach the coax cable to the antenna through the mounting bracket, locking the antenna
into place.