Murphy M2, Руководство по установке

Страница: 18 / 38

Section 50 00-02-0674
04-16-10 - 14 -
Installing Remote Units
Read MODBUS address 40016. This will contain the remote ID of the next remote you will be
adding to the network. Label the next remote to be added with the value contained in address
40016. This is done to create a reference between the remote and the MODBUS map.
NOTE: The first 8 remote units correspond to Gateway LEDs 1 through 8.
Additional remotes will use LED 8 to display sensor events.
When a sensor event occurs, a heartbeat is missed,
or the remote‟s
battery is low, the Gateway will light up the appropriate LED 1 through 8.
1. Loosen the 4 screws and remove the lid to the remote
enclosure. Take out the PC board and place it onto the
lid. Set aside for later.
2. Place 2 wraps of Teflon tape in a clockwise fashion
around threaded connection as shown.
3. Run sensor wires into the remote case, leaving a few
inches of extra wire outside of the case.
4. Attach the remote case to the sensor or conduit, leaving
the case opening face up.
5. Snap the battery into place on the back side of the pc board,
aligning the +/- as indicated below.
NOTE: Use only Tadiran TL-5903-S 3.6 volt Lithium batteries . ( See
How to Install a Battery in the Remote .)
6. Replace the PC board into the casing, battery side down.