START UP:
Air within the bottle filler system or the structure supply piping will cause an irregular spout outlet stream until
purged out by incoming water. Press and hold pushbutton until steady water stream is achieved.
SENSOR OPERATION INSTRUCTIONS:
Hold container to be filled just below the sensor in the center of the filler spout and then move the container
upward and water flow will start automatically. When the container is almost filled, lower the container below
the sensor until the water stops flowing. (see label on the bottle filler)
HAND OPERATION INSTRUCTIONS:
Hold container to be filled just below the filler tube in the center of the unit, then push pushbutton. When the
container is almost filled, release the pushbutton.
WATER TUBING CONNECTIONS:
NOTE:
Insulation on all water tubes not shown (all PE water tubes are insulated).
MURDOCK MFG. •
15125 Proctor Avenue • City of Industry, CA 91746 USA
Phone 800-453-7465 or 626-333-2543 • Fax 626-855-4860 • www.murdockmfg.com
Member of
7013-037-001
Revised: 07/26/18
Page 5 of 16
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
Semi-Recessed Bottle Fillers
Keys
1/4" NCT x 1/4" OD
"Y" Strainer
(Chiller Inlet)
1/4" NCT x 1/4" OD
Push-In Union
(Chiller Outlet)
Electrical
Knockout
Thermostat
Adjustment
Removable
Access Door
18" PE Tubing
Air-Control Valve
Inlet Fitting
Air-Control Valve
Outlet Elbow
w/ Flow Control
Fill Spout
