Figure 8.6.18
The WSN802G module must be awake in order to use the
Serial Data
tab. To hold the module awake,
place a jumper on JP14, which is labeled ALWAYS ON or push and hold the WAKE IN button. The
IP
Address
and
Port Number
on the I/O Read tab refer to the WSN802G module’s Sensor socket. Clicking
Send Data
sends the string in the
Transmit Data
text box in a SERIAL_DATA command to the module. A
quick reply to the command is indicated by a
Successful
Status
. A
Failure Status
is usually caused by
forgetting to install a jumper on JP14.
Figure 8.6.19
The WSN802G module must be awake in order to use the
IO Write
tab. To hold the module awake, place
a jumper on JP14, which is labeled ALWAYS ON or push and hold the WAKE IN button. The
IP Address
and
Port Number
on the I/O Read tab refer to the WSN802G module’s Sensor socket. Clicking the
Write
button under
GPIO Out Values
sends an IO_WRITE_GPIO to the module. Clicking the
Write
button under
©2009-2015 by Murata Electronics N.A., Inc.
HN-210D/X, HN-214 D/X Rev. 2.0 01-16-15
Page 84 of 101
www.murata.com
