21
© Munters Corporation, August 2021
QM1077r16
Motor Key
Step 23
If Fans are to be installed 60” O.C., cut the 3 o’clock and 9 o’clock guard wire in the position shown. Push the
side of the cone in as far as possible and fasten the cut guard wire to the attached guard wire using Clamp [JJ].
See Figure 23.
Figure 23
Installation Instructions
Chapter 2
Step 24
Find the Key provided with the Motor and place it in the Keyway on the motor shaft. Place the Motor Sheave
on the Motor shaft with the hub facing towards the motor.
See Figure 24.
ONLY tighten the set screw enough
to hold the Sheave in place at this time.
Figure 24
Motor Sheave
Motor
2.5 Motor Mounting
Cut Guard Wire Here
Clamp [JJ]
Note:
When wiring motor, check rotation of propeller.
Internal wiring of motor may need to be changed
to assure proper rotation of propeller.
