17
© Munters Corporation, August 2021
QM1077r16
Step 17
From the inside attach S-Hooks [Y] to hole in upper or lower plate of Main Frame, from the door side through the
Main Frame toward the outside. Then attach each Tension Spring to S-Hook [Y] using end of spring with Hook.
Stretch spring and insert opposite end into hole drilled in door previously.
See Figure 17.
Figure 17
Installation Instructions
Chapter 2
Step 18
Place all 4 cone sections on a flat surface with tabs from one facing slots of the next.
See Figure 18A.
Curl up tab end of first cone section and insert tabs up into slots in the next cone section. A mallet may be
needed to seat slots over tabs completely.
See Figure 18B.
Repeat this step until all 4 cone sections are
connected and laying flat.
2.4 Cone Installation
Figure 18A
Figure 18B
Hole in upper plate
Drilled Hole in
Damper Door
Tension Spring
Tension Spring
Drilled Hole in Damper Door
S-Hook [Y]
Tension Spring
S-Hook [Y]
