© Munters AB, 2014
11
Procedure:
1. remove the cover from the controller housing for the connection;
2. all 3 cable entry points are in a sealed condition at delivery; remove plastic fastener if necessary, and insert
cable gland, entry points that are not used must remain sealed;
3. insert and connect lines correctly;
4. attach cover of controller housing again carefully in correct position before startup.
5.3 Assembly instructions
fig.4
Click the two rolling junctions together as in the zoom
showing the cut of the pipe.
Installation
Chapter5
•
Temperatures up to 85°C can be present on the controller housing;
•
to connect, always use heat resistant wires or, as an alternative, silicon tubes;
•
self-tapping screws are used for the ‘PE’ conductor connection; these cannot
be loosened and sufficiently retightened infinitely;
•
remants from installation and foreign object may not remain on the inside.
Warning
!
For detailed electric connection instructions for Munters Drive motor refer to
Munters Drive motor manual.
Warning
!
