FR64/67 — THRU-BOLT INSTALLATION
The FR67 is supplied with a mounting gasket 13T42173 to replace the original Ford PTO cover
gasket. This gasket replaces the need for the O-Ring shown in detail B. The O-Ring groove has
been removed from the PTO housing and the gasket must be used when mounting the PTO. The
gasket can be used in the FR64 units also. The gasket is located in kit 43TK5183.
FORD vehicles with GAS engines and FR64/67 PTOs are supplied with heat Shield Kit 49TK5533.
Detail A
Detail B
Detail A
Install O-ring followed by the washer BEFORE placing
the hex head capscrew into the mounting hole
Detail B
Be sure the O-ring (located in the housing mounting pad)
is in place during the head capscrew installation
Detail A
Detail B
Detail A
Install O-ring followed by the washer BEFORE placing
the hex head capscrew into the mounting hole
Detail B
Be sure the O-ring (located in the housing mounting pad)
is in place during the head capscrew installation
201 East Jackson Street • Muncie, Indiana 47305
800-367-7867 • Fax 765-284-6991 • [email protected] • www.munciepower.com
Specifications are subject to change without notice. Visit www.munciepower.com
for warranties and literature. All rights reserved. © Muncie Power Products, Inc. (2012)
A Member of the Interpump Group
SP11-05 (Rev. 02-18)
