How to Use
How to Use
8
9
1
.
Choose the correct adapter for your baby
bottle (see Included Adapters on page 7).
Ensure the gaskets are installed in the warming
unit and adapter (gasket identification letter
facing up).
Screw the adapter into the neck of the warming
unit.
If no adapter is needed, proceed to step 2.
2
.
Fill the baby bottle with water (for formula) or
breast milk.
NOTE:
Warm water first, then mix in powdered
formula once heating cycle is complete.
For best results do not use to heat premixed
formulas or alternative milks.
3
.
FLIP THE WARMING UNIT UPSIDE DOWN
and screw the baby bottle into the unit or
adapter. Twist until the bottle is pressed firmly
against the gasket to ensure a watertight seal.
~4 mins
~5 mins
~6.5 mins
~5.5 mins
~7 mins
~9 mins
STARTING MILK TEMPERATURE
22°C (72°F)
5°C (42°F)
VOLUME
4oz/120ml
6oz/180ml
8oz/240ml
4
.
Open the rubber cover on the back of the
warming unit, then insert the power cord. Plug
the cord into an electrical outlet.
The standby mode is ready and display will
blink 00.0, it will automatically stop after 30
seconds if no action is taken.
NOTE:
When the warmer turns off after 30
seconds of no action. PRESS AND HOLD the
button once for 2 seconds to activate the
standby mode. Next PRESS and HOLD again
for 2 seconds to activate the heating cycle.
5
.
Make sure the warming unit is right side up
when standby mode is ready and then press
and hold the power button for
two seconds
to
start warming. The digital 37.0°C display will
turn on.
NOTE:
Based on most common standard sized bottles.
~4 mins
means “approximately 4 minutes”
The warming durations are to be used as a guide only. Bottle style and size, liquid starting
temperature and volume can impact the warming speed and final temperature.
For optimal heating temperature use with 120ml/4oz to 240ml/8oz of liquid.
WARMING TIMES
