mumbi m-FS300, Руководство пользователя

Страница: 12 / 16

12
Notes
• The wireless sockets are switched on and off using the remote control (ON/OFF
button).
• When the buttons are activated, the red LED on the remote control illuminates
briefly. However, the red LED on the wireless socket remains illuminated for as
long as it is switched on.
• The range reduces if the signal has to pass through ceilings, doors, windows or
walls (environment dependent).
• The ON/OFF button in the “ALL” area can be used to switch all wireless sockets
on or off at the same time.
• Do not connect electrical consumers with a higher resistive load than 5A.
• Do not connect tungsten filament lamps which exceed a wattage of 100w.
• Do not connect electrical consumers with inductive loads containing motor
capacitors (such as refrigerators).
Tips
If the remote control is not working, check ...
1. ... whether the battery has been inserted correctly.
2. ... whether the battery is empty; if the battery is empty, please replace it
with an equivalent battery.
• Avoid getting the battery contacts wet.
• Do not install the wireless socket in the immediate vicinity of transformers as
these can affect the wireless connection.
• Please do NOT exceed the maximum values (please refer to the specifications).
• If possible, do not use the wireless socket for devices with a high switch-on
voltage (motors, etc.).
If you cannot detect a perceptible noise, the wireless socket is not connected to
the remote control. Please repeat the “Commissioning” procedure.
1. ... whether the selected socket is working properly.
2. ... whether the wireless unit is connected.
3. ... whether the device to be connected is functional.
4. ... whether the inserted device is switched on - assuming it has
an ON/OFF switch.
EN