Multitech TalkAnytime TA2410, Руководство пользователя

Страница: 46 / 235

URL Configuration TalkAnytime Quick Start Instructions
46
Connectivity Test
The procedures “Phone/IP Starter Configuration” and “Phonebook Starter Configuration” must be
completed before you can do this procedure.
1. The setup for testing connectivity is shown below. The settings in the
T1/E1 Parameters screen must be
made to fit your PBX and overall system.
IP Addr= 65.129.90.2
Settings:
Voice/Fax Coder field: Automatic
T1/E1 Params: per system needs
Inbound Phonebook
Channel 1
Description
field: test-xyz
Ethernet
Hub
Command
PC
IP Addr= 65.129.90.3
URL://65.129.90.2/tat.cgi?
Service=test-xyz&
Protocol=TCP&
Codec=G723&
Digits=Yes
Setup for Connectivity Test
T1/E1
Connection
TalkAnytime
TA2410 or
TA3010
Ethernet
Port
PBX
Digital Voice
Trunk Port
After the settings shown here have been made in the TalkAnytime Configuration program, click on Save
Setup .
2. From a browser at the command PC, type in the test URL with “Digits=Yes.” At the TalkAnytime client
software, click
Dial
. You will then hear a dial tone coming back from the PBX. Enter the designated PBX
extension on the TalkAnytime dial pad (on the screen). The phone at the designated PBX extension
should ring.
If a connection is made and the designated phone extension of the PBX rings, then connectivity has been
demonstrated.
If a connection cannot be made, skip to
Troubleshooting below. Troubleshooting involves a ping test. If
you can ping the TA-2410/3010 successfully but cannot make a call, then there may be a problem with
your T1/E1 Parameters settings. Check those settings and re-test.
If a connection cannot be made, skip to Troubleshooting below.
3. The LEDs on the front panel of the TalkAnytime unit will also help you confirm connectivity. If the TA-
2410/3010 is configured correctly and connected properly, the ONL LED should be on, and the LC and
LS LEDs should be off.