Multitech MultiVOIP 200 MVP200, Руководство пользователя

Страница: 50 / 113

50
MultiVOIP 200 User Guide
Deploying the VOIP Network
For a Proprietary Phone Directory database, the VOIP administrator can deploy the pre-configured Client
MultiVOIP 200s to their remote sites. The remote site administrators need only connect power to the pre-
configured MultiVOIP 200, connect the MultiVOIP 200 to their Ethernet LAN and predefined telephone equipment,
and then wait for the phone directory database to be downloaded.
With the Gatekeeper option enabled on the Phone Directory Database dialog box, all MultiVOIP 200s are
configured as “Host” and cannot be downloaded. In this case, each MultiVOIP 200 Phone Book will be
programmed with phone numbers for its own channels. These phone numbers are registered with the H.323
Gatekeeper (See the “Registering with a Gatekeeper Phone Directory” section discussed earlier.
Remote Site Administrator
The following steps are for MultiVOIP 200 H.323 endpoints. For non-MultiVOIP 200 H.323 endpoints,
refer to the appropriate installation documentation.
1. Unpack your MultiVOIP 200.
2. Connect one end of the power supply to a live AC outlet and connect the other end to the Power
connection on your MultiVOIP 200 (See Figure 5).
FXS E&M
FXO
PSTN
Ethernet Connection
Power Connection
10BASET
ETHERNET POWER
Voice/Fax Channel
Connections
E&M FXO FXS
Figure 5. Remote Site Cable Connection
3. Connect a network cable to the ETHERNET 10Base-T (RJ-45) connector on the back of your
MultiVOIP 200.
4. If you are connecting a station device (e.g., analog telephone, fax machine, or Key Telephone
System (KTS) to your MultiVOIP 200, connect the smaller end of a special adapter cable
(supplied) to the Voice/Fax Channel 1 FXS connector on the back of the MultiVOIP 200 and the
other end to the station device.
If you are connecting a PBX extension to your MultiVOIP 200, connect the smaller end of a
special adapter cable (supplied) to the Voice/Fax Channel 1 FXO connector on the back of the
MultiVOIP 200 and the other end to the PBX extension.
If you are connecting an E&M trunk from a telephone switch to your MultiVOIP 200, connect one
end of an RJ-45 phone cord to the Voice/Fax Channel 1 E&M connector on the back of the unit
and the other end to the trunk phone jack.
If you are connecting to an E&M trunk, you need to ensure that the E&M trunk jumper is in the
correct position for the E&M type trunk. The default E&M jumper position is E&M type 2. To
change the E&M jumper position, perform the E&M jumper block positioning procedure.
5. Repeat the above step to connect the remaining telephone equipment to each Voice/Fax
Channel on your MultiVOIP.
6. Turn on power to the MultiVOIP 200 by placing the ON/OFF switch on the back panel to the ON
position. Wait for the BOOT LED on the MultiVOIP 200 to go OFF before proceeding. This may
take a couple of minutes.
7. At this time your VOIP network should be fully operational. Dial one of the sites in your network.