Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F)
33
Example 4 – Set Up the Ethernet Router to Activate on Matching Caller IDs Only:
1.
On the
PPP > PPP Configuration
screen, set up the following parameters:
PPP General
•
Make sure that
PPP
is
Enabled
(the default).
•
Make sure
Dial-on-Demand
is
Enabled
(the default).
•
Set the
Idle Time Out
to the number of seconds you desire.
Authentication
•
Your wireless service provider may require you to have a separate PPP
username
and
password
. If so, enter them here. Note: If a username and password are required, your
wireless provider would have given them to you when you activated your account.
Modem Configuration
•
Make sure your
Dial Number
is entered correctly:
For
CDMA
, it is
#777
For
GPRS and EDGE
, it is
*99***1#
•
Make sure your
Init String 1
is setup correctly.
For
GPRS and EDGE
,
Init string 1
should be the APN
(i.e.,
AT+CGDCONT=1,"IP","internet"
)
Submit
•
Click the
Submit
button to save the changes made on this screen.
2.
On the
PPP > Wakeup-on-Call
screen, set up the following parameters:
Wakeup-on-Call Configuration
•
Select
Enable
for
Wakeup-on-Call
.
•
Set the
Time Delay
. Use can use the 10 second default.
•
Enter the
Init Strings:
Set Wakeup
Init String 1
by entering
AT+CLIP=1
Set Wakeup
Init String 2
by entering
AT+CICB=0
(CDMA only)
•
Submit
Button
Click the
Submit
button to save these settings.
Caller ID Configuration
•
Enter a caller’s ID that you want added to the Caller ID list.
•
Add
Button
Click the
Add
button to save each Caller ID as it is entered to the Caller ID list.
3. Save and Restart
Click
Save and Restart
once you have completed and submitted all the screens on which you
have made changes. The device will save all the settings and reboot the PC.
