Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F)
32
Example 2 – Determine if the Wireless Modem Is Supporting Incoming Calls and Caller ID
1.
On the
PPP > PPP Configuration
screen, make sure that
PPP
is
Disabled
.
2.
On the
PPP > Wakeup-on-Call
screen, make sure that
Wakeup-on-Call
is
Disabled
.
3.
Open a command prompt by clicking the
Start
button and selecting
Run
.
4.
Type
CMD
to open the command window. Click
OK
.
5.
When the command window opens, type
Telnet 192.168.2.1 5000
Note:
5000 is the port number.
5.1.
Enter your user name and password to login.
5.2.
Enter an AT command to make sure you receive a response; i.e.,
OK
.
5.3.
Enter the Command
AT+CNUM
to determine the dial number of your wireless modem.
Note:
For a CDMA modem, you might have to enter the command
AT+CICB=0
6.
From another phone, call your modem using the number identified in Step 5.3. This will let you know if
the RING message shows.
7.
To enable Caller ID, enter the
AT+CLIP=1
command on the command screen and make the call again
to see if it shows Caller ID information.
Notes:
•
Step 5.3 must show the RING or CALLER ID information in order for the Wakeup-on-Call function to
work.
•
Some wireless providers might not provide caller ID information if you have only a data plan.
Example 3 – Set Up the Ethernet Router to Activate on ALL Incoming Calls
1.
On the
PPP >PPP Configuration
screen, set up the following parameters:
PPP General
•
Make sure that
PPP
is
Enabled
(the default).
•
Make sure
Dial-on-Demand
is
Enabled
(the default).
•
Set the
Idle Time Out
to the number of seconds you desire.
Authentication
•
Your wireless service provider may require you to have a separate PPP
User name
and
Password
. If so, enter them here. Note: If a user name and password are required, your
wireless provider would have given them to you when you activated your account.
Modem Configuration
•
Make sure your
Dial Number
is entered correctly:
For CDMA
, it is
#777
For GPRS and EDGE
, it is
*99***1#
•
Make sure your
Init String 1
is setup correctly.
For GPRS and EDGE
,
Init string 1
should be the
APN
.
Example:
AT+CGDCONT=1,"IP","internet"
Submit
•
Click the
Submit
button to save the changes made on this screen.
2.
On the
PPP > Wakeup-on-Call
screen, set up the following parameters:
Wakeup-on-Call Configuration
•
Select
Enable
for
Wakeup-on-Call
.
•
Set the
Time Delay
to
3
seconds. You can use the 10 second default.
•
All
Init Strings
should be empty.
•
Submit
Button
Click the
Submit
button to save these settings.
Caller ID Configuration
•
Enter the string
RING
to the Caller ID list.
•
Click the
Add
Button to save the string to the Caller ID list.
3. Save and Restart
Click
Save and Restart
once you have completed and submitted all the screens on which you
have made changes. The device will save all the settings and reboot the PC.
