Appendix A – Regulatory Information
MT9234MU-CDC-XR User Guide
21
This equipment is not capable under all operating conditions of correct operation at the higher speed which it is
designated. 33.6 kbps and 56 kbps connections are likely to be restricted to lower bit rates when connected to some
PSTN implementations. Telecom will accept no responsibility should difficulties arise in such circumstances.
2.
Immediately disconnect this equipment should it become physically damaged, and arrange for its disposal or repair.
3.
This modem shall not be used in any manner which could constitute a nuisance to other Telecom customers.
4.
This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There is no guarantee that
Telecom lines will always continue to support pulse dialing.
Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to ‘bell
tinkle’ or noise and may also cause a false answer condition. Should such problems occur, the user should not contact
the Telecom Faults Service.
The preferred method of dialing is to use DTMF tones, as this is faster than pulse (decadic) dialing and is readily
available on almost all New Zealand telephone exchanges.
5.
Warning Notice: No ‘111’ or other calls can be made from this device during a mains power failure.
6.
This equipment may not provide for the effective hand-over of a call to another device connected to the same line.
7.
Some parameters required for compliance with Telecom’s Telepermit requirements are dependent on the equipment
(PC) associated with this device. The associated equipment shall be set to operate within the following limits for
compliance with Telecom’s Specifications:
For repeat calls to the same number:
●
There shall be no more than 10 call attempts to the same number within any 30-minute period for any single
manual call initiation, and
●
The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt and the
beginning of the next attempt.
For automatic calls to different numbers:
●
The equipment shall be set to ensure that automatic calls to different numbers are spaced such that there is no
less than 5 seconds between the end of one call attempt and the beginning of another.
For automatically answered incoming calls:
●
The equipment shall be set to ensure that calls are answered between 3 and 30 seconds of receipt of ringing.
8.
For correct operation, total of the RNs of all devices connected to a single line at any time should not exceed 5.
South African Notice
This modem must be used in conjunction with an approved surge protection device.
Thailand Approval
Translation in Thai
“This telecom device and equipment is conform to technical standard no….”
or
“This telecom device and equipment is conform to requirement to NTC”
“
เครื่องโทรคมนาคมและอุปกรณ์นี้
มีความสอดคล้องตามมาตรฐานทางเทคนิค
เลขที่
.........”
or
“
เครื่องโทรคมนาคมและอุปกรณ์นี้
มีความสอดคล้องตามข้อก าหนดของ
กทช
.”
