Figure 2
Figure 3
Figure 4
Attaching the Mounting Bracket
To attach the mounting bracket to the Base Station:
Attach the bracket to the back of the Base Station using the supplied screws and washers as shown.
Mounting on a Pole
To attach the Base Station on a pole:
Attach the Base Station to the pole using the supplied hose clamps.
Installing the Ground Wire
Proper grounding of metal enclosure is required to ensure safety. The ground lug is located on the enclosure
back as shown in the
Back
image (under
Connector Locations
). Connecting the ground lug to an earth ground is
the recommended method. Refer to the National Electric Code or your local codes for additional information or
contact a licensed electrician for assistance in grounding an installation.
Ground wire (not provided) must be suitable for outdoor location and meet a minimum wire gauge of 14awg or larger. Use
the supplied ground screw to fasten wire.
Ground wire terminal must be closed loop (ring type, see image right) and corrosive free in design. Insert screw
though loop terminal and fasten to 15 lbf-in (17.28 kgf-cm).
Attaching Accessories
If you purchased the accessory kit, attach the lightning arrester to the LoRa connector on the top of the Base Station. Attach
antennas and the Ethernet cable to the connectors as labeled.
Installing the Lighting Arrester
Proper grounding of the lightning arrester is required to ensure proper operation. Connecting the ground lug on the lightning
arrester to the earth ground is the recommended method. Please refer to the National Electric Code (or your local codes) for
additional information or contact a licensed electrician for assistance.
Additional Information
For Base Station dimension drawings, MultiConnect Conduit regulatory information and instructions for using the
MultiConnect Conduit, go to
www.multitech.net/developer/products/conduit
.
Regulatory Information
This device complies with Part 15 of the FCC rules and with ICES-003 of Industry Canada for a Class A digital apparatus. Operation
of this device is subject to the following conditions: (1) This device may not cause harmful interference and (2) This device must ac-
cept any interference that may cause undesired operation.
MultiTech declares that this device is in compliance with the essential requirements and other relevant provisions of Directive
2014/53/EU. The declaration of conformity may be requested at
https://support.multitech.com
.
Safety Instructions
For safety and to achieve a good installation, please follow these safety precautions:
Consider safety and performance when selecting an installation site. Remember electric power lines and phone lines look alike.
Assume that any overhead line can kill.
Call your power company and ask them to look at your proposed installation. This is important if raising a mast or tower.
When installing the device:
Do not use a metal ladder.
Do not work on a wet or windy day.
Do dress properly—shoes with rubber soles and heels, rubber gloves, long sleeved shirt or jacket.
If any part of the antenna system comes in contact with a power line, do not touch it or try to remove it yourself. Call your local power
company. They will remove it safely. If an accident occurs, call for emergency help immediately.
Mounting on a Wall
To mount the device on a wall:
Use the four bracket tabs to attach the Base Station to the wall with the supplied screws and anchors.
