background image

CallFinder Configuration Guide: AltiGen IP Phone System

  

 

Introduction 

Multi-Tech CallFinder

® 

Cellular Gateway is an ideal solution for  

 

Reducing cellular telecom costs 

 

Cellular wireless communication backup 

 

Primary voice network for remote locations or temporary work sites 

The gateway is connected to an analog trunk port on the AltiGen IP phone system.  The user simply dials the 
desired cell phone number and the phone system’s routing table will hand off the call to the port connected to the 
CallFinder.  From there, the CallFinder will route the call over the wireless network. 

The CallFinder also provides an affordable back-up communication network during times of emergency.  In the 
case of a PSTN failure, it will bridge the AltiGen IP phone system to the cellular network providing an alternate 
route.  In a disaster situation, it will even establish critical communication, including emergency 911 service.   

In addition, the CallFinder gateway provides a fast, easy fixed line alternative for small offices, SOHO environments 
or other remote locations. Simply connect an analog phone to the gateway and the user can make affordable 
cellular calls over the GSM network. There is no need for fixed wiring, making it an ideal solution to any 
environment where a fixed line is not readily available, such as mobile centers or retail kiosks. 

Network Topology

 

 

There are two models of CallFinder Cellular Gateways: 

1.  GSM Model – CF100FX2-G 
2.  CDMA Model – CF100FX2-C 

 
The focus of this document is to provide set-up and configuration instructions to support a MobileExt call from 
AltiServ to a cellular phone network.  

 

Physical Topology 

 

Requirements 

AltiServ: 

Software

 

– 

AltiWare 5.1 Update1 and AltiWare 5.0A with Update 4 or above.

 AltiWare 5.1 support dynamic 

trunk sharing for MobileExt operation while AltiWare 5.0A requires dedicated trunk channels to support MobileExt. 

Hardware 

– Triton or MAX1000 analog trunk port for Multi-Tech CF100FX2-G (GSM one port) and CF100FX2-C 

(CDMA one port) 

CallFinder: 

Software 

– CallFinder Version 3.00 for GSM and 2.06 for CDMA

 

  

 

Содержание CallFinder CF100FX2








Отзывы: