Read complete instructions prior to installation and operation of the unit.
WARNING :
Risk of electric shock.
SAFETY PRECAUTION
All safety related codifications, symbols and instructions that appear in this operating manual or on the equipment
must be strictly followed to ensure the safety of the operating personnel as well as the instrument.
If all the equipment is not handled in a manner specified by the manufacturer, it might impair the protection
provided by the equipment.
WARNING GUIDELINES
WARNING : Risk of electric shock.
1. To prevent the risk of electric shock, power supply to the equipment must be kept OFF while doing the wiring
arrangement. Do not touch the terminals while power is being supplied.
2. To reduce electro magnetic interference, use wire with adequate rating and twists of the same of equal size shall be
made with shortest connection.
3. Cable used for connection to power source, must have a cross section of 1mm or greater.These wires should have
insulations capacity made of at least 1.5kV.
4. A better anti-noise effect can be expected by using standard power supply cable for the instrument.
MECHANICAL INSTALLATION GUIDELINES
1) To install the instrument on a DIN rail, raise the clamp at the back of the instrument and place it on the rail.
Now release the clamp, so the instrument fits on the DIN rail.
2) Ensure proper fitting of the instrument by pulling it outwards.
3) To remove the instrument raise the clamp to release it from the DIN rail.
4) The equipment in its installed state must not come in close proximity to any heating source, caustic vapors,
oil steam, or other unwanted process byproducts.
5) Do not connect anything to unused terminals.
INSTALLATION GUIDELINES
1. This equipment, being built-in-type, normally becomes a part of main control panel and in such case the terminals do
not remain accessible to the end user after installation and internal wiring.
2. Do not allow pieces of metal, wire clippings, or fine metallic fillings from installation to enter the product or else it may
lead to a safety hazard that may in turn endanger life or cause electrical shock to the operator.
3. Circuit breaker or mains switch must be installed between power source and supply terminal to facilitate power
‘ON’ or ‘OFF’ function. However this mains switch or circuit breaker must be installed at convenient place normally
accessible to the operator.
4. Use and store the instrument within the specified ambient temperature and humidity ranges as mentioned in
this manual.
Product improvement and upgrade is a constant procedure.
Multispan reserves the right to change specifications without prior notice.Printing and typographical errors reserved.
Multispan Control Instruments Pvt. Ltd.
72/B,Phase 1, GIDC Estate,Vatva,Ahmedabad-382445,Gujarat,India.
www.multispanindia.com
Followus
+91-9978991476/9978991474/9978991482
