MULTIQUIP MQ Power Whisperwatt DCA220SSCU, Руководство по эксплуатации и запасным частям

Страница: 25 / 90

dca220sscu/4i 60 hz generaTor• operaTion manual — rev. #0 (10/25/12) — page 25
GeNeratOr OUtpUts/GaUGe reaDiNG
hoW To read The ac ammeTer and ac
volTage gauges
The AC ammeter and AC voltmeter gauges are controlled
by the AC ammeter and AC voltmeter change-over switches.
Both of these switches are located on the control panel and
do noT effect the generator output. They are provided to
help observe how much power is being supplied, produced
at the UVWO terminals lugs.
Before taking a reading from either gauge, configure the
Voltage Change-Over Board (Figure 13) which produces
the desired output voltage.
Figure 13. Voltage Change-Over Board
240/3
Ø Position
ac voltmeter gauge reading
Place the AC Voltmeter Change-Over Switch (Figure 14)
in the W-U position and observe the phase to phase voltage
reading between the W and U terminals as indicated on
the
AC Voltmeter Gauge
(Figure 15).
Figure 14. AC Voltmeter
Change-Over Switch Figure 15. AC Voltmeter Gauge
(Volt reading on W-U Lug)
ac ammeter gauge reading
Place the AC Ammeter Change-Over Switch (Figure 16)
in the U position and observe the current reading (load
drain) on the U terminal as indicated on the AC Ammeter
Gauge
(Figure 17). This process can be repeated for
terminals V and W.
Figure 16. AC Ammeter
Change-Over Switch
Figure 17. AC Ammeter
(Amp reading on U Lug)
NOTICE
The ammeter gauge will only show a reading when
the
Output Terminal Lugs
are connected to a load
and in use.