MULTIQUIP Mikasa MVH406DSZ, Руководство по эксплуатации и запасным частям

Страница: 18 / 94

MVH-406DSZ PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #2 (08/13/07) — PAGE 19
While the engine is running, never try to turn the ignition key to
the
START position.
6. After starting the engine, continue to warm up the engine
for about 3 to 10 seconds especially in cold weather.
7. If the buzzer does not stop sounding after the engine has
started, shutdown engine immediately and check engine
oil level. The buzzer functions as a engine oil level alarm
warning device.
Recoil Start
1. Move the throttle lever to the START position (Figure 16).
2. Grasp the starter grip (Figure 17) and slowly pull it out. The
resistance becomes the hardest at a certain position,
corresponding to the compression point.
3. Pull the starter grip briskly and smoothly for starting.
4. If the engine does not start, repeat steps 2 and 3.
Figure 17. Engine Start Handle
When starting a unit with an electric start capability,
a decompressor is not normally required. However,
when ambient temperature or battery charger level
is low, use of a decompressor will help make the
start-up easier.
TRAVELING
Make sure to follow all safety rules referenced in the safety section
of this manual before operating compactor. Keep work area
clear of debris and other objects that could cause damage to the
compactor or bodily harm.
Figure 18. Throttle Lever (Fast)
1. Grasp the compactor's hand grip (Figure 18), and move the
engine throttle lever (Figure 18) quickly to the fast position.
2. With the throttle lever in the fast position, the engine speed
should be around 3,400 RPM, therefore engaging the cen-
trifugal clutch.
CAUTION
CAUTION
MVH-406DSZ — OPERATION
ALWAYS move the throttle lever quickly without
hesitation, because increasing the engine
speed slowly causes the clutch to slip.
Figure 19. Travel Lever
3. To make the compactor move in the forward direction push
the travel lever ( Figure 19) forward.
1
2