MULTIQUIP Mikasa MVH406DSZ, Руководство по эксплуатации и запасным частям

Страница: 17 / 94

PAGE 18 — MVH-406DSZ PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #2 (08/13/07)
Adjusting Handle Height
The height of the handle is adjustable for your comfort .
1. Loosen the butterfly screw (Figure 14).
2. Turn the grip clockwise to raise the handle or counterclock-
wise to lower the handle.
3. When the handle is raised to the desired height, tighten the
butterfly screw.
MVH-406DSZ — OPERATION
Figure 14. Handle Adjustment
Electric Start
1. Place the throttle lever (Figure 15) in the START position
(center). Place the travel lever in the neutral position
(center)
Figure 15. Travel/Throttle Lever (Start Positions)
STARTING THE ENGINE
2. Insert the ignition key into the ignition switch and turn it to
the
RUN position (Figure 16). The buzzer should sound at
this time.
3. Turn the ignition key further to the right to the START
position to start the engine. Buzzer stops sounding and the
engine starts.
4. If the engine fails to start, DO NOT continue to rotate the
ignition key for more than 5 seconds. Return the key to the
RUN position and wait 10 seconds before starting again
Figure 16. Starter Switch (Option)
DO NOT attempt to operate the compactor
until the Safety, General Information and
Inspection sections of this manual have
been
read and thoroughly understood
.
This section is intended to assist the
operator with the
initial start-up of the
compactor. It is extremely important that this section be read
carefully before attempting to use the compactor in the field.
Refer to Figure 3 for the location of controls and components .
Releasing the Handle
1. Pull the handle release pin, (Figure 13) then push down on
the hand grip to release the handle.
Figure 13. Handle Release Pin
CAUTION