MULTIQUIP Mikasa MDR-9DYE, Руководство по эксплуатации и запасным частям

Страница: 22 / 90

PAGE 22 — MQ-MIKASA MDR-9DYE VIBRATORY ROLLER — PARTS & OPERATION MANUAL — REV. #0 (12/19/03)
MDR-9DYE — OPERATION
VIBRATING
1. Shift the two vibrator levers (Figures 21 and 22) to the
vibrate position to start vibrations.
Using vibration with clutch slipping causes
the clutch to burn. Also, vibration should
NOT be used over completely compacted
area, paved road surface, or with stationary
roller.
CAUTION :
WATERING
1. To operate water sprinkling system, turn on the front and
rear water valves on the side of the roller. (Figure 23).
Figure 21. Vibrator Lever
Figure 22. Vibrator Lever (Body)
Figure 23. Water Valves
2. To make the roller move in the reverse direction pull the travel
lever ( Figure 20) backwards.
3. Firmly gasp the roller's hand grip, the roller will begin moving
in the desired position when the direction lever has been
placed in the desired position.
Make sure to follow all safety rules referenced in
the safety section of this manual before operating
roller. Keep work area clear of debris and other
objects that could cause damage to the roller or
bodily injury.
CAUTION :
1. To make the roller move in the forward direction push the
travel lever ( Figure 20) forward. This roller has a hydraulic
variable speed transmission. By moving the travel lever
varioys increments, you can vary the speed from 0 to 1.8 mph
(0 to 3 km/hr).
Figure 20. Travel Lever
TRAVELING
DO NOT reduce speed during work. When
shifting travel lever from forward to reverse,
be sure to stop the lever at the neutral
position first before moving the lever to the
opposite direction.
DO NOT shift the lever
from forward to reverse (or reverse to
forward) in one motion.
CAUTION :
After test travel, shut down engine and
check for any problems including oil
leakage. If any trouble is found, correct the
problem before attempting to operate the
roller again.
CAUTION :