MULTIQUIP Mikasa MDR-9D, Руководство по эксплуатации и запасным частям

Страница: 22 / 104

PAGE 22 — MQ-MIKASA MDR-9D VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #0 (12/17/03)
MDR-9D — OPERATION
VIBRATING
1. Shift the two vibrator levers (Figures 21 and 22) to the
vibrate position to start vibrations.
Using vibration with clutch slipping
causes the clutch to burn. Also, vibration
should
NOT be used over completely
compacted area, paved road surface, or
with stationary roller.
CAUTION :
WATERING
1. To operate water sprinkling system, turn on the front and
rear water valves on the side of the roller. (Figure 23).
Figure 21. Vibrator Lever
Figure 22. Vibrator Lever (Body)
Figure 23. Water Valves
STOPPING
1. Place the vibrator and travel levers to the neutral position.
2. Slow down the engine and allow to cool for at least 2
minutes. Place speed control lever in the stop position
and listen for the engine to stop running.
3. The hydraulic brake is automatically engaged when the
travel lever is in neutral position. When parked on a slope
with the engine turned off, place a block against the
roller drum to prevent the roller from moving.
CAUTION :
NEVER attempt to stop the engine by
moving the decompression lever. Always
use the speed control lever to stop engine.
UNLOADING
1. If you need to move the roller by pushing it manually
once engine is stopped, push in the upper and lower
knobs of the transmission check valve. This will
cause the hydraulic break to disengage and allow
t h e r o l l e r t o b e m o v e d w i t h o u t c a u s i n g
damage(Figure 24).
2. After moving, reset upper and lower knobs.
NEVER tow roller with any type of vehicle.
Doing so will damage the hydraulic
system.
NEVER perform unloading procedure on
a slope. This may cause roller to roll down
if parking brake or blocking is deficient.
CAUTION :
Figure 24. Disengaging Hydraulic Brake