LT6KV LIGHT TOWER • OPERATION MANUAL — REV. 2 (07/08/16) — PAGE 11
SAFETY INFORMATION
TRANSPORTING SAFETY
CAUTION
Before lifting, make sure that light tower parts are not
damaged and screws are not loosened or lost.
ALWAYS
make sure crane or lifting device has been
properly secured to lifting hook of the equipment.
NEVER
lift the equipment while engine is running.
Make sure the tower is in the stowed position before
lifting.
Ensure the knob is tightened securely at the front of the
mast.
If lifting through pockets, make sure forks of forklift are
inserted in pockets as far as possible before lifting.
NEVER
allow any person or animal to stand underneath
the equipment while lifting.
DO NOT
lift equipment to unnecessary heights.
STOWED POSITION
ALIGN
STOW ARROW
LIGHT TOWER
FORKLIFT POCKETS (2)
Loading and Tie-Down on Flatbed Truck
NOTICE
Before loading light tower to fl atbed truck, disconnect all
four fl oodlight connectors and tie-wrap the cables against
the T-bar to prevent damage to the cables and connectors.
When loading onto fl atbed truck, make sure that front
jackstand of light tower is retracted and in the horizontal
position so that the foot does not make contact with the
deck fl oor.
Make sure that the two side (left and right) and two rear
jackstands are in the vertical postion, slightly extended,
so that each foot makes contact with the deck fl oor.
Straps and chains should be routed through the transport
tie-down points located beneath each corner of the
cabinet to allow even application of force to the front
and rear of the machine.
DO NOT
secure the unit by running a strap or chain over
the tongue of the light tower. This may cause severe
damage to the unit.
CABLE
TIE
ALIGN
STOW ARROW
CABLE (X4)
CONNECTORS
DISCONNECTED
TONGUE
FRONT
JACKSTAND
RETRACTED
TRANSPORT TIE-DOWN
POINT (4)
SIDE
JACK
STAND
(2)
REAR JACK
STAND (2)
