DIS185SSI4F AIR COMPRESSOR — HOSE REEL INSTALLATION INSTRUCTIONS P/N EE60468 — REV. #0 (04/16/18) — PAGE 9
5. Using the pivot base (P/N 59272) as a guide, drill two
13/32-inch holes into the top of the fender as shown
in Figure 18.
Figure 18. Drill Pivot Base Holes
6. Insert two 3/8-16 × 1-1/4" hex flange bolts (P/N 1023)
through the new holes in the fender with two 3/8"-16
hex flange nuts (P/N 21781), and tighten securely.
See Figure 19.
Figure 19. Secure Pivot Base to Fender
7. If installing the dual hose reel kit (P/N MQPDUALREEL50),
repeat steps #1–6 with the left pivot base (P/N 59273)
on the battery side of the air compressor.
DRILL TWO
13/32" HOLES
PIVOT BASE
P/N 59272
FENDER
FENDER
3/8-16 × 1-1/4"
HEX FLANGE BOLT
P/N 1023
3/8"-16 HEX
FLANGE NUT
P/N 21781
SIDE MARKER INSTALLATION
1. Strip the insulation back 1/4-inch (6 mm) from the
ends of the wires extending from the back of the side
marker light bulb socket to expose the conductors.
See Figure 20.
Figure 20. Strip Side Marker Wires
SIDE MARKER
LIGHT BULB
STRIP
INSULATION 1/4"
SOCKET