MULTIQUIP DA7000SSA2, Руководство по эксплуатации и запасным частям

Страница: 20 / 160

PAGE 20 — DA7000SSA2/SSA2GH GENERATOR• OPERATION AND PARTS MANUAL — REV. #0 (03/26/15)
28.
AC Voltmeter
— This voltmeter indicates (with a
mark) the rated 60 Hz (single-phase) output voltage.
In addition the voltmeter can also be used as a
diagnostic tool. If the voltmeter indicator (needle) is
below the rated voltage, engine problems may exist
(low/high RPM's). To prevent damage to the generator
or power tools turn the generator OFF and consult your
authorized Multiquip service dealer.
29.
Hour Meter
— Indicates number of hours machine
has been in use or hours engine was run.
30.
Idle Control Switch
— The generator is provided with
an automatic idle control device for noise suppression
and reduced fuel consumption.
The automatic idle control automatically engages under
a no-load condition. With the automatic idle control
switched “
ON
”, the engine revolutions will automatically
drop to about 2200 rpm (low-speed operation) within
3 seconds after the load stops. When the operation is
resumed, the engine speed is automatically increased
28
29
30
31
32
33
to about 3600 rpm (high-speed operation) as soon as
the load is connected.
31.
Warning Lamp Display
— Lights red when the
following conditions occur:
„
Oil Pressure Lamp — If the oil pressure drops
suddenly, the oil pressure lamp will go on, and
the generator will shut down.
„
Charge Lamp
— The charge lamp will go on
when loss of engine alternator charge exists and
the generator will shut down.
„
Water Temperature Lamp — The water
temperature lamp will go on if the temperature
rises to an abnormally high level, and the
generator will shut down.
32. Starter Switch — With key inserted turn clockwise to
start engine.
33. Ground Terminal — Used to connect exernal
equipment ground so that the GFCI receptacle will
have a ground path.
Figure 5. Generator Components (3 of 3)
COMPONENTS (GENERATOR)