Multiplex S250M 10, Инструкция по установке, использованию и уходу

Страница: 23 / 30

Section 4 Maintenance
Part Number 020002115 10/11
4-3
Disassembly
DISASSEMBLY FOR CLEANING & MAINTENANCE
NOTE: Sanitize the ice dispenser at Initial Start-up in
addition to monthly sanitizing. You will need a slotted
screwdriver in order to disassemble.
Disassemble parts in the following order:
A. Merchandiser
B. Ice chute
C. Paddle wheel or agitator pins
D. Agitator
E. Paddle wheel
F. Bin liner
G. Paddle wheel area
Accessing a Dispenser Bin Top Mounted with a Manitowoc
Ice Machine:
1. Remove the front panel of the ice machine.
2. Remove the ice deflection baffle. This will give you
access to the dispenser bin.
3. If the Manitowoc ice maker is operating, wait for the
sheet of ice to fall into the dispenser bin.
When the ice sheet falls into the dispenser bin, immediately
place toggle switch of the ice machine to the OFF position. If
the Manitowoc ice maker is NOT operating, place the toggle
switch of the ice machine to the OFF position.
4. On models without a top mounted ice maker, remove
the plastic lid from the top of the dispenser.
5. Remove all ice from the dispenser.
6. Disconnect electrical power to the dispenser.
7. Remove agitator arm and paddle wheel pin.
a. With agitator arm in any position remove hitch clip
pin from the mushroom bushing on the rear of the
ice bin.
b. Push the agitator bar toward the bushing to remove
it from the paddle wheel hub.
NOTE: If a top mount ice maker is installed, sliding the ice
maker to one side will make bin component removal easier.
If the ice maker is hard plumbed it will need to be
disconnected.
Beverage/Ice Dispenser
8. Remove paddle wheel, bin liner and paddle wheel area.
9. Move the front of the agitator to one side and slide the
agitator forward until the rear of the agitator shaft is clear
of the bushing.
10. Remove the agitator from the bin area.
11. Slide the paddle wheel from its shaft.
12. Loosen the four knurled fasteners that hold the bin liner
in place.
13. Remove the bin liner.
14. Remove the paddle wheel area from the bin.
15. Discard the remaining ice in the bin.
C
D
E
F
G
A
B