Recommended Installation Procedure
Doc. No 10-8381
Release 1.0, 1/14/2005
Page 6 of 6
8.0.2
Use caution when removing layers. Splicing
shears or a cable knife may be used to start the
removal by placing a small knick at the point where
the layer joins the grommet.
Figure 11
8.0.3
Pull on the layer at the location of the nick.
Figure 12
8.0.4
Any differential between the OD of the cable
and the adjusted ID of the grommet can be made up
with a layer of sealing tape included in each closure
kit.
8.0.5
Place a layer of silicone grease around the
inside diameter of the grommet where the cable will
seat.
8.0.6
Install the grommets on the cable with the
Square end flush up against the strain relief placed
earlier and face the grommet slit up.
Figure 13
NOTE:
Squeeze the two strain relief clamps tight to
the grommet flange
8.0.7
Apply a thin layer of Silicone Grease to the
gaskets entire surface of the lower and upper end
plates of the closure.
See Figure 14
Figure 14
8.0.8
Apply a liberal layer of Silicone Grease on the
exterior surface of the grommet and lower the
assembly down into the lower end plate of the
closure
. Refer to Figure 15
Figure 15
