MULTILIFT ULTIMA S, Руководство по установке

Страница: 19 / 62

Installation
Ultima Hooklift 01/2020
19
3.7 Installation plates
The installation plate kits are available to various truck chassis models. The standard kit is
meant to hooklift lengths max 59. For the longer hooklifts additional plate kits are available and
they usually follow the hooklift delivery.
The installation plate kit contains the flexible brackets 2-4 pairs for the front part of the hooklift
and the fixed plates for the middle and rear part of the hooklift.
Flexible brackets, 2 - 4 pairs Fixed plates Rear plates
The predrilled holes in the truck chassis must be utilized, whenever possible.
The flexible brackets are installed to both sides of front cross member. The tightening torque of
the vertical M16 8.8 bolts is 22 ft-lb - ¼ turns. Some truck manufacturers are requesting to use
Belleville springs with vertical bolts in heavy conditions. Check truck manufacturer’s instruc-
tions.
NOTE! If the hooklift is equipped with front locking then there must be fixed installation
plates underneath the lock.
First installation plates towards the rear from flexible brackets must be large plates or doubled
smaller plates. The large plates are necessary also under the middle frame / rear frame shaft.
When mounting the smaller plates the distance between the plates must be equal. The maxi-
mum distance of 43 ft must not be exceeded.
The rear beam is fastened to chassis with 6 x M14 (M16) fastening bolts on both sides.
Some truck manufacturers request M16 chassis fastener bolts (e.g. MB). Check the truck man-
ufacturer’s instructions.