multicomp pro MP720644, Быстрое руководство

Страница: 17 / 33

Multicomp-Pro
15
Introduction to the Horizontal System
Shown as Figure 3-11 , there are a button and two knobs in the Horizontal Controls .
The following practices will gradually direct you to be familiar with the setting of
horizontal time base.
Upper knob : adjust horizontal position
When the HOR
button is lit
Lower knob : adjust horizontal scale
Figure 3-11 Horizontal Control
1. When the HOR button is lit, push the HOR button to switch between the normal
mode and the wave zoom mode.
2. When the HOR button is lit, turn the B knob to change the horizontal time base
setting and observe the consequent status information change. Turn the B knob to
change the horizontal time base, and it can be found that the Horizontal Time
Base displayed in the status bar changes accordingly.
3. When the HOR button is lit, use the A knob to adjust the horizontal position of
the signal in the waveform window. The A knob is used to control the triggering
displacement of the signal or for other special applications. If it is applied to
triggering the displacement, it can be observed that the waveform moves
horizontally with the knob when you rotate the
A knob.
Triggering displacement back to 0 shortcut key
Turn the A knob to change the horizontal position of channel and push the A
knob to set the triggering displacement back to 0 as a shortcut key.
Introduction to the Trigger System
As shown in Figure 3-12 , there are one knob and one button make up Trigger
Controls . The following practices will direct you to be familiar with the setting of the
trigger system gradually.