User Manual
12
How to Use the Probe Safely
The safety guard ring around the probe body protects your finger against any electric
shock, shown as
Figure 3-9 Finger Guard
Warning:
To avoid electric shock, always keep your finger behind the safety guard
ring of the probe during the operation.
To protect you from suffering from the electric shock, do not touch any
metal part of the probe tip when it is connected to the power supply.
Before making any measurements, always connect the probe to the
instrument and connect the ground terminal to the earth.
How to Implement Self-calibration
The self-calibration application can make the oscilloscope reach the optimum
condition rapidly to obtain the most accurate measurement value. You can carry out
this application program at any time. This program must be executed whenever the
change of ambient temperature is 5
℃
or over.
Before performing a self-calibration, disconnect all probes or wires from the input
connector. Push the
Utility
button, select
Function
in the right menu, select
Adjust
.
in the left menu, select
Self Cal
in the right menu; run the program after everything is
ready.
Introduction to the Vertical System
, there are a few of buttons and rotary controls in
Vertical
Controls
. The following practices will gradually direct you to be familiar with the
using of the vertical setting.
