Page <28>
V1.0
07/01/22
Newark.com/multicomp-pro
Farnell.com/multicomp-pro
sg.element14.com/b/multicomp-pro
3) [AF Trigger►]
Set the AF triggering conditions.
• [AF Trigger On Off]
Set the AF trigger to be On or Off.
• [Edge Pos Neg]
Set the trigger to rising or falling edge.
•
[Trigger Mode]
Set the triggering mode to single trigger or continuously trigger.
•
[Trigger Level]
Set the trigger level as a percentage of the depth.
•
[Trigger Delay]
Set the trigger delay time.
• [Return]
Return to the previous menu.
5.13 [Peak]
Executes peak searching immediately and opens the Peak setting menu.
Key Points:
•
If Max is selected from the Peak Search option, it will search and mark the maximum on the trace.
• The peak search of Next Peak, Peak Right, Peak Left or peaks in the peak table must meet the specified parameter
condition.
• The spurious signal at the zero frequency caused by LO feed through is ignored.
5.13.1 [Max Search]
Place a frequency scale at the highest point of the trace and display the frequency and amplitude of the frequency scale in
the upper right corner of the screen. [Max search] does not change the activated function.
5.13.2 [Next Peak]
Searches the peak whose amplitude is the closest to that of the current peak. The peak is then identified with a marker. When
this key is pressed repeatedly, you can quickly find a lower peak.
5.13.3 [Left Peak]
Searches the nearest peak located to the left side of the current peak and meets the current peak and peak thresholds
condition. The peak is then identified with a marker.
5.13.4 [Right Peak]
Searches the nearest peak located to the right side of the current peak and meets the current peak and peak thresholds
condition. The peak is then identified with a marker.
5.13.5 [Min Search]
Searches the peak with the minimum amplitude on the trace and identifies it with a marker.
5.13.6 [Mkr→CF]
Used to move the peak point to the center frequency point.
5.13.7 [Cont Max On Off]
Set the peak search form, off by default. On mode will automatically search for the peak.
