Seven: Programming for Use with Z-Wave Devices
63
Providing a brighter solution.™
Including Z-Wave Devices into the Network
This procedure includes Z-Wave devices into a network controlled by the PE953 Hand-Held
Controller. The PE953 is pre-configured to operate with the PE653 Receiving Device. The
PE953 can also operate as a stand alone Z-Wave remote controller. Z-Wave devices from other
manufacturers may be part of the same network as the PE953 and PE653, and depending on
supported features, can act as repeaters.
If necessary, press and release any button on the Hand-Held
1.
Controller to wake it from sleep.
If the screen is not displaying
LEARN MODE, press and hold the
<P/S>
and
<ENTER>
buttons at
the same time to put the device into programming mode. You are in
programming mode when the LEARN MODE screen is displayed, as
shown at the right.
Press and release the
2.
<3>
function button to select
INCLUDE
DEVICE
. The screen refreshes with instructions to PRESS BUTTON
ON DEVICE TO INCLUDE, as shown.
Press the button on the Z-Wave device for including the device in a
3.
network (refer to the manufacturer’s instructions).
If the action is successful, the screen displays the word
SUCCESSFUL, as shown, then returns to the programming screen.
NOTE:
If the two devices are not successfully linked and you are
seeing the word
FAILURE
at the bottom of the screen, carefully repeat the procedure. If the
problem persists, contact Intermatic Customer Service.
Repeat this procedure for all other Z-Wave home control devices that are to be part of the network.
4.
Press the
5.
<ENTER>
button if you wish to return to the Main screen.
Including the PE653 Receiver onto a non-Multi-Wave remote
controller
The PE653 is a Z-Wave compliant device that may be included into networks created by other
manufacturer’s Z-Wave compliant controllers.
To include the PE653 into another manufacturer’s controller:
1. Activate the controller’s INCLUDE function according to that manufacturer’s instructions.
1.
2. Press and release the INCLUDE button on the PE653.
2.
If the include was successful, the red flashing LED on the PE653 will change to steady ON. (The
steady ON LED will flash rapidly whenever another device is communicating with it.)
To exclude the PE653 from another manufacturer’s controller:
Activate the controller’s EXCLUDE function according to that manufacturer’s instructions.
1.
Press and release the INCLUDE button on the PE653.
2.
If the exclude was successful, the red flashing LED on the PE653 will change from steady ON to
slowly flashing ON and OFF.
LEARN MODE 00-00P
1 RESET CONTROLLER
2 RESET DEVICE
3 INCLUDE DEVICE
4 ADD TO SCENE
5 REMOVE FROM SCENE
UP-PREVIOUS DWN-MORE
LEARN MODE 00-00P
3 INCLUDE DEVICE
PRESS BUTTON ON
DEVICE TO INCLUDE
LEARN MODE 00-00P
3 INCLUDE DEVICE
PRESS BUTTON ON
DEVICE TO INCLUDE
SUCCESSFUL
