Chapter 5 – QuickCarrier USB HSPA (MT100UCC-H3)
QuickCarrier Developer’s Guide
27
CAUTION:
Unless you are certain that the drivers for your USB device are already installed on the
computer, make sure that you check
Install the modem driver
. Failure to do this will
cause the application to incorrectly detect your device or not detect the device at all.
Note:
Because serial devices do not require drivers, it does not matter if you check or uncheck
Install the modem driver
for a serial device.
8.
To specify a folder for Connection Manager, use the default folder or click
Change
to browse to the
folder you want to use.
9.
Click
Install
.
A separate wizard opens for installing Telit drivers. Some MultiTech devices use embedded
modules from Telit Wireless Solutions to provide cellular connectivity; these devices require Telit
drivers.
10.
Select
Complete
setup type.
11.
When the drivers are installed, click
Finish
.
12.
In the Setup Wizard, click
Finish
.
Note:
●
To open Connection Manager after installation, check Start the MultiTech Connection
Manager when the installation is finished.
●
After the drivers are installed, you need to restart your computer if prompted by
Windows.
If using a USB device, you can connect the device to the carrier's network with Connection Manager. Refer
to
If using a serial device, you need to set up the device in Windows Device Manager before connecting the
device. Refer to
Setting Up a Serial Device in Windows Device Manager
Setting Up a Serial Device in Windows Device Manager
To set up the device in Windows Device Manager:
1.
Make sure that your desired COM port for the serial device is available.
2.
Connect the serial device to the PC.
3.
Go to
Control Panel
>
Device Manager
. Make a note of the COM port number for the connected
device (in
COM Ports
).
Example: The COM port is
COM31
.
4.
Go to
Action
>
Add legacy hardware
.
