Multi-Tech MT5634ZPX, Руководство пользователя

Страница: 24 / 108

MT5634ZPX
24
Owner’s Manual
Non-PnP COM Ports & IRQ Address --Type 2 Board
If you alter the Type 2 board factory setting (PnP) only by
repositioning the top jumper to bridge the “1-2” pins, the resulting
configuration is IRQ=3 on COM 4. This can be considered the
default setting for non-PnP operation. Other configurations can
be chosen as shown in Figure 2-7.
The COM port for the Type 2 board is set using the bank of three
Berg jumpers. The first position of the jumper bank, when
occupied, selects the Non-Plug-N-Play mode. The other
positions are used to set the COM port. See Figure 2-7
(* denotes the factory default setting for non-PnP operation).
These configurations are also marked on the board itself, below
the IRQ jumper bank.
COM 3 COM 4*
6 5
2 1
Non-Plug-N-Play COM 2
6 5
2 1
6 5
2 1
6 5
2 1
Figure 2-7. COM Port Jumpers (Type 2 Board)
To assign an IRQ address, place the IRQ jumper in the desired
position. Figure 2-8 shows the jumpers in the default position of
IRQ3. The IRQ address you chose should be one that does not
conflict with others used by other devices connected to your
computer. The MT5634ZPX Type 2 board supports these
values: 3, 4, 5, 7, 9, 10, 12, and 15.
IRQ15 IRQ12 IRQ10 IRQ9 IRQ7 IRQ5 IRQ4 IRQ3
Figure 2-8. IRQ Jumpers (Type 2 Board)