Multi-Tech MT5634ZPX, Руководство пользователя

Страница: 17 / 108

MT5634ZPX
17
2 Installation
Safety Warnings
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
• This product is to be used with
UL and CUL listed computers.
• Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network
interface.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during
an electrical storm. There may be a remote risk of electrical
shock from lightning.
• Do not use a telephone in the vicinity of a gasleak.
• To reduce the risk of fire, use only No. 26 AWG or larger
Telecommunication line cord.
Installation
Installation will be slightly different for the two different circuit
boards (Type 1 or Type 2) commonly used in the MT5634ZPX.
The Type 1 board contains a four-position DIP switch for COM
port assignment and nine Berg jumpers for setting the IRQ
address. On the Type 1 board, the DIP switch and jumpers are
located at the upper left corner of the PC board (see Figure 2-1).
The factory default for the Type 1 board is Plug-N-Play
(automatic COM port and IRQ address assignment). See
FIgure 2-3.
The Type 2 board contains a bank of three Berg jumpers for
COM port assignment and a bank of eight Berg jumpers for
setting the IRQ address. The COM port jumpers are in the lower
left corner of the board (Figure 2-2); the IRQ jumpers are near
the center of the board (Figure 2-2). The factory default for the
Type 2 board is Plug-N-Play operation (see Figure 2-4). For
non-Plug-N-Play operation, the user can re-position the COM